The supplied flow and pressure to the MP-F are
dependant on the intensification ratio chosen. The table below shows the
flow and pressure for each model. Flow Q1 is when the pump pressure has been
reached, and flow Q2 is when moving up the vertical part of the pressure
curve. For information on the flow-pressure curve press
| Ratio |
Inlet Flow (max.) (LPM / GPM) |
Outlet Flow Q1 (LPM / GPM) |
Outlet Flow Q2 (LPM / GPM) |
Inlet Pressure (max.) (Bar / Psi) |
Outlet Pressure (Bar / Psi) |
| 2.0 | 8.0 / 2.1 | 0.8 / 0.21 | 0.2 / 0.08 | 200 / 2,900 | 400 / 5,800 |
| 3.4 | 15.0 / 4.0 | 2.2 / 0.58 | 0.5 / 0.13 | 200 / 2,900 | 680 / 9,860 |
| 4.0 | 14.0 / 3.7 | 1.8 / 0.47 | 0.4 / 0.10 | 175 / 2,538 | 700 / 10,150 |
| 5.0 | 14.0 / 3.7 | 1.4 / 0.37 | 0.3 / 0.08 | 140 / 2,030 | 700 / 10,150 |
| 7.0 | 13.0 / 3.4 | 1.1 / 0.29 | 0.2 / 0.05 | 100 / 1,450 | 700 / 10,150 |
 |
The MP-F pressure intensifier is
a flange-on model, designed to be mounted onto a hydraulic block. The MP-F
will increase a supplied pressure to the higher end pressure required (max.
700 Bar / 10,150 psi). Having all high pressure valves incorporated,
including the POV, a pilot operated check valve, for relieving the high
pressure side, the MP-F offers a cost effective solution for intensifiction
needs. Conrolling the high pressure side is done by valves on the low
pressure side through the MP-F, allowing the MP-F to be installed in most
new and existing hydraulic circuits. The MP-F intensifier is offered with 5 different intensification ratios as standard with additional ratios on
request to meet most intensification requirements. For more information on
the POV check valve press
|
The MP-F Pressure Intensifier |
